Rancang Mesin Press Pneumatik Pada Geram
| Main Author: | Kusmindar, Muksin |
|---|---|
| Format: | Thesis NonPeerReviewed Book |
| Bahasa: | eng |
| Terbitan: |
, 2019
|
| Subjects: | |
| Online Access: |
http://eprints.umm.ac.id/50308/54/PENDAHULUAN.pdf http://eprints.umm.ac.id/50308/6/BAB%20I.pdf http://eprints.umm.ac.id/50308/7/BAB%20II.pdf http://eprints.umm.ac.id/50308/8/BAB%20III.pdf http://eprints.umm.ac.id/50308/9/BAB%20IV.pdf http://eprints.umm.ac.id/50308/10/BAB%20V.pdf http://eprints.umm.ac.id/50308/12/lampiran.pdf http://eprints.umm.ac.id/50308/13/poster.pdf http://eprints.umm.ac.id/50308/ |
Daftar Isi:
- Along with the development of equipment requirements and supporting production work, especially in machining work that uses machine tools, therefore it is necessary to have an innovation of production aids to facilitate the work carried out. In conventional work processes with machine tools including the lathe process of the milling process and the scrap process. growling the result of this incision is production waste that is not handled properly it can cause problems because of irregular forms of growling, some are in the form of powder, small pieces, elongated sprial shapes, longitudinal or screw-shaped wire forms. Pneumatic is a driving system that uses air pressure as its driving force. The pneumatic workings are the same as the hydraulics that deter it from the driving force. If the pneumatic uses air as its driver while the hydraulic uses oil fluid as the driving force. The results of this research on the design of the power needed to drive a pneumatic cylinder are 1.18 HP and the piston power produced 2.1144 J. The shape of the results of the pressed growling is a rectangle (beam) with a width of 20 cm and a height of 50 cm.