PERANCANGAN TABUNG KOMPRESOR UNTUK ALAT PENGISIAN OLI TRANSMISI DAN DIFERENSIAL MENGGUNAKAN SISTEM PNEUMATIK DENGAN KOMPRESSOR TIPE DIRECT DRIVEN
| Main Author: | Kirami, Anwar |
|---|---|
| Format: | Thesis NonPeerReviewed |
| Terbitan: |
, 2013
|
| Subjects: | |
| Online Access: |
http://eprints.umm.ac.id/16098/ |
Daftar Isi:
- When implementing the Job Training (PKL) at PT. KIA Nusantara authors observed a transmission oil and deferensial oil fill tool. Where the workings of the utilization of wind as the driving medium oil is still using a manual pump that would only require power for pumping oil, and it is difficult for one person to use it. Then along with the progress of time the producers to develop back then, which is still used today turned into a manual and automated by using aeration using a compressor, here the author tries to innovate back from transmission oil and deferensial oil fill tool using pneumatic power. Tube type compressor pressure vessel is a pressure vessel that has an internal pressure or pressure in the course. The things that need to be considered in the planning of tube compressors are as follows: working pressure, design pressure, maximum pressure, operating temperature, the maximum allowable stress value. In planning the design of pressure vessels such as tube compressor authors chose ASME standards as reference in designing tubes 1. 0 MPa pressure air compressor with a capacity of 10 L. Tube materials used adalh SA 283 Gr A steel with 45,000 psi tensile large, the stress Value Of Shell Material of 10350 Psi and its temperature 70°C. Based on the calculation of the tube wall thickness (shell) and head tube (head) with Semi-Elliptical head shape (2:1). From the calculation results obtained with a 3mm thick shell tube length 319 mm, thickness 3 mm Head tube and tube diameter of 200 mm.