Daftar Isi: Pulses Model of Electrical Discharge Machining (EDM)

Main Authors:	Minhat, Ade Erawan; Department of Electronic and Computer Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, Johor Bahru, Hj Khamis, Nor Hisham; Department of Communication Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, Johor Bahru, Yahya, Azli; Department of Electronic and Computer Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, Johor Bahru, Andromeda, Trias; Department of Electronic and Computer Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, Johor Bahru, Nugroho, Kartiko; Department of Biotechnology and Medical Engineering, Faculty of Biosciences and Medical Engineering, Universiti Teknologi Malaysia, Johor Bahru
Format:	Article info eJournal
Bahasa:	eng
Terbitan:	IAES Indonesia Section , 2014
Subjects:	Electrical Discharge Machining Pulse Width Modulation gap current gap voltage
Online Access:	http://journal.portalgaruda.org/index.php/EECSI/article/view/414 http://journal.portalgaruda.org/index.php/EECSI/article/view/414/276

Daftar Isi:

This article presents a model of pulses inElectrical Discharge Machining (EDM) system. There areseveral mathematical models have been successfully developedbased on the initial, ignition and discharge phase of currentand voltage gap. According to these models, the circuitschematic of transistor pulse power generator has beendesigned using electrical model in Matlab Simulink software toidentify the profile of voltage and current during machiningprocess. Then, the simulation results are compared withexperimental results.